3. TV Features
23
For assistance call 1(800) 332-2119
Microphone Placement
Be sure the
height of the
microphone is
within three feet
of the speaker
height.
Center the micro-
phone in front of
the TV.
Set the microphone
on a level surface at
ear height at least
six feet from the TV.
Use a seat backrest
or tripod so as to
pick up sound from
all directions.
Maximum height above speakers
Microphone
TV
6 ft. minimum
Microphone
Height of TV
speakers
3 ft.
Sound Projector, continued
Adjusting Beam Angles
3.
a.
Adjust
Center Beam Angle
until sound is
about equal in both ears.
b.
Adjust
Left Beam Angle
to maximize sound
heard from the front left side.
c.
Adjust
Right Beam Angle
to maximize sound
heard from the front right side.
d.
Adjust
Left Surround Beam Angle
to where
the sound seems to come from the left rear
side. If this cannot be achieved, make the
setting the same as that for Left Beam Angle.
e.
Adjust
Right Surround Beam Angle
to where
the sound seems to come from the right rear
side. If this cannot be achieved, make the
setting the same as that for Right Beam Angle.
Adjusting Levels
4.
a.
Adjust
Center Level
to the mid level.
b.
Adjust the following levels one at a time so that
each one sounds about the same as the center
level:
Left Level
Right Level
Left Surround Level
Right Surround Level
c.
Check all sound levels by quickly switching
between them using .
d.
Readjust individual levels in small increments
and recheck as above until all sound levels
seem about the same.
Resetting Angle and Level Values in the
Custom Menu
Press
1.
EXIT
to clear all menus.
Press
2.
MENU.
Go to the
Sound > SoundPro
menu
and press
ENTER
.
Change any setting (e.g.,
3.
TV Location
).
Press
4.
EXIT
to clear all menus.
Press
5.
MENU.
Go to the
Sound > SoundPro
menu
and press
ENTER
.
Enter the correct values for the room layout.
6.
Return to the
7.
CUSTOM
menu to adjust angles and
levels.
Auto Setup
265 Series
This section describes auto-setup available with 265 series
TVs. Auto setup uses the included calibration micro-
phone.
Power on the TV and external subwoofer, if any.
1.
Plug the microphone cable into the TV’s
2.
INPUT 2
left audio jack.
Place the microphone as described in the guide-
3.
lines.
Press
4.
MENU
and go to
Sound > AutoSP.
Highlight
5.
START
and press
ENTER
.
Quietly exit the room right away.
6.
Wait for completion
of setup before returning to the room.
Play some sample audio material to check the
7.
sound quality.
Note:
Do not perform manual adjustments after run-
ning Auto setup.
Store the microphone out of direct sunlight and
8.
away from heat.
