PHOTOS
OPERATION PROCEDURE
9. REMOVING THE HEAT EXCHANGER AND LEV
(1) Remove the front panel (Refer to 2.) and the corner panel
at right lower side.
(2) Remove the electrical box (Refer to 4.) and the nozzle
assembly (Refer to 5.).
(3) Remove the motor band.
(4) Remove the pipe thermistors (Refer to 8.).
(5) Disconnect the connector (CN60) on the indoor controller
board and the connector for ground wire. (See Photo 5)
(6) Remove the screws fixing the left side of the heat
exchanger. (See Photo 11)
(7) Remove the heat exchanger with LEV.
10. REMOVING THE ROOM TEMPERATURE THERMISTOR
(1) Remove the front panel (Refer to 2.).
(2) Remove the electrical box cover.
(3) Remove the room temperature thermistor.
(4) Disconnect the connector (CN20) on the indoor controller
board.
NOTE: When room temp. thermistor is replaced, be sure
to use service parts No. R01 N20 202.
Photo 14
Photo 16
Electrical box cover (top)
Electrical box cover (side)
Screw (side cover)
Screw (top cover)
Switch board cover
Holder of wireless
controller board
Nozzle assembly
Water cover
Copyright 2009 MITSUBISHI ELECTRIC ENGINEERING CO., LTD.
Distributed in Apr. 2009 No. OCH460 PDF 7
Made in Japan
New publication, effective Apr. 2009
Specifications subject to change without notice
HEAD OFFICE : TOKYO BLDG., 2-7-3, MARUNOUCHI, CHIYODA-KU TOKYO 100-8310, JAPAN
Screw
(side
cover)
Indoor controller board (I.B)
Terminal
block (TB2)
Fixture
(right)
Room temp. thermistor (TH21)
Fixture
(right)
Terminal
block (TB5)
Terminal
block (TB15)
Room temp. thermistor
(TH21)
Wire clip
Photo 17
Photo 15
Heat
exchanger
LEV
Ground wire