Mitsubishi Electric PD-4265, Руководство по обслуживанию

Страница: 13 / 127

PD-5065
13
*1 Only when using a graphic accelerator board that is capable of displaying 852 x 480.
*2 The picture is displayed in the original resolution. The picture will be compressed for other signals.
*3 The aspect ratio is 5:4. This signal is converted to a 720 dots x 768 lines signal.
*4 Normally the RGB select mode suite for the input signals is set automatically. If the picture is not displayed
properly, set the RGB mode prepared for the input signals listed in the table above.
*5 To connect the monitor to Macintosh computer, use the monitor adapter (D-Sub 15-pin) to your computer’s
video port.
*6 Other screen modes (EXPAND and STRETCH) are available as well.
*7 When viewing a moving picture at a vertical frequency greater than 65Hz, the picture may sometimes be
unstable (jumpy). If this occurs, please set the refresh rate of the external equipment to 60Hz.
To view 480I@60Hz (480 interlaced lines, 60Hz refresh rate) or 576I@50Hz (567 interlaced lines, 50Hz
refresh rate) when sync polarity is “Sync on Green”, set “RGB SELECT” to “MOTION”.
*8 CVT standard compliant.
NOTE:
•
While the input signals comply with the resolution listed in the table above, you may have to adjust the position and
size of the picture or the fine picture because of errors in synchronization of your computer.
• This monitor has a resolution of 1024 dots x 768 lines. It is recommended that the input signal should be XGA, wide
XGA, or equivalent.
•
With digital input some signals are not accepted.
• The sync may be disturbed when a nonstandard signal other than the aforementioned is input.
•
If you are connecting a composite sync signal, use the HD terminal.
• “ IBM PC/AT” and “XGA” are registered trademarks of International Business Machines, Inc. of the United States.
• “ A pple Macintosh” is a registered trademark of Apple Computer, Inc. of the United States.