7
6.3. Unit function selection
This setting method is for slim air conditioners. For City multi models, set the DIP switches on the indoor PC board and outdoor PC board.
To set the DIP switches, refer to the technical materials for the City multi models.
Set the functions as necessary using the remote controller. The functions for each unit can be set only from the remote controller.
Select the functions from table 1 that must be set.
Only the refrigerant systems that are connected to indoor units equipped with wireless remote controller receivers can be set from the wireless re-
! !
Table 1 Function selection settings (For details about the factory settings and modes of each indoor unit, refer to the indoor unit
installation manual.)
k
#: ! #
refer to the indoor unit installation manual for details.
Mode
Settings
Mode no.
Setting no.
Initial setting
Setting
Power failure automatic recovery
Not available
01
1
Select unit
number 00.
Available
2
Indoor temperature detecting
Indoor unit operating average
02
1
Set by indoor unit’s remote controller
2
Remote controller’s internal sensor
3
LOSSNAY connectivity
Not Supported
03
1
'; =
2
Supported (indoor unit is equipped with fresh =
3
Filter sign
100Hr
07
1
Select unit
number
01–04 or AL
(all units).
2500Hr
2
k
3
Fan speed
Silent
08
1
Standard
2
High ceiling
3
Number of air outlets
4-directional
09
1
3-directional
2
2-directional
3
Installed option
;&!=
Without
10
1
With
2
Up/down vane setting
Not setting
11
1
Equipped with vanes (vanes angle setup
1
)
2
Equipped with vanes (vanes angle setup
2
)
3
&
Not equipped
13
1
Equipped
2
Note: Whenever the function selection is used to change the indoor unit functions after installation, be sure to record all of the set-
! "#$ "% $&
