– 20 –
GB
Set the functions of each indoor unit from the remote controller, as required.
Refer to the Indoor unit Installation Manual for factory settings, mode No., and the setting No. of the
indoor units.
■
Setting the indoor unit Setting Value
4
Press the
and the
buttons to set the address of the indoor unit whose
settings to be made. (ALL, 1 to 50)
5
Press the
button, then press the
and the
buttons to set the
Function Setting No. to be set. (000 to 255)
6
Press the
button, then press the
and the
buttons to set the
Function Setting Value. to be set (00 to 15)
7
Press the
button to set the settings.
9
Function Selection for CITY MULTI
1
Press the
button to stop the operation of the air conditioner.
2
Press and hold down the
and the
buttons at the same time for two seconds
or longer to check the current settings.
3
When the response has been received from the indoor unit, the current settings appear. If
there is no response, nothing appears.
Make this setting only when the function settings need to be changed on CITY MULTI.
(This setting cannot be made with Mr. SLIM Control System. To make settings for Mr. SLIM,
refer to section
.)
8
Function Selection for Mr. SLIM
NOTE: Be sure to write down any settings that you change performing the following steps.
ON
OFF
+
Air conditioner
stops.
Procedure A
2 sec.
Function Setting Value
Function Setting No.
Indoor unit address
Response is received.
Response has been received.
No response
No
response
Waiting for response
..
..
..
..
..
..
ON
OFF
WT06592X01.book Page 20 Monday, April 16, 2012 10:38 AM
