Mitsubishi Electric PAC-YT52CRA, Руководство по установке

Страница: 19 / 24

– 19 –
GB
6
Mode No. selection
Select the mode No. you want to set with the
B
and
C
buttons. (Only the
settable mode numbers can be selected.)
7
Select the setting contents of the selected mode.
When the
D
button is pressed, the current setting No. flashes. Use this to check the
currently set contents.
Select the setting No. using the
B
and
C
buttons.
8
The contents set at steps
3
to
7
are registered.
When the
A
button is pressed, the mode No. and setting No. flash and registration begins.
The flashing mode No. and setting No. change to a steady light and setting ends.
* When “ ” flashes at the Mode No. display, communication is probably abnormal.
Make sure there are no noise sources near the transmission line.
-------------------------------------------------------------------------------------------------------------------------------------
9
To select more functions, press the
D
and repeat steps
3
to
8
.
-------------------------------------------------------------------------------------------------------------------------------------
0
End function selection.
Press and hold down the
C
and
D
buttons at the same time for two seconds or
longer.
After a while, the function selection display disappears and the remote controller returns to the air
conditioner off display.
* Do not operate the air conditioner from the remote controller for 30 seconds after the end of
function selection.
.. ..
Mode No. display
Mode No. 02 = Thermistor selection
.. ..
Setting No. display
Setting No. 1 =
Average temperature
reading of the indoor
units in operation
Setting No. 3 =
Built-in sensor on the
remote controller
ON
OFF
..
NOTE: When the functions of an indoor unit were changed by function selection after the end
of installation, always indicate the set contents by entering check marks or other marks
in the appropriate check field of Table 1.
WT06592X01.book Page 19 Monday, April 16, 2012 10:38 AM