Mitsubishi Electric MSY-GN25VF, Руководство по эксплуатации

Страница: 4 / 12

En-3
● OPERATING INSTRUCTIONS ●
• Press CLOCK gently using a thin instrument.
RESET
CLOCK
RESET
CLOCK
• Make sure the polarity of the batteries is correct.
• Do not use manganese batteries and leaking batteries. The remote controller could
malfunction.
• Do not use rechargeable batteries.
• The battery replacement indicator lights up when the battery is running low. In about
7 days after the indicator starts lights up, the remote controller stops working.
• Replace all batteries with new ones of the same type.
• Batteries can be used for approximately 1 year. However, batteries with expired
shelf lives last shorter.
• Press RESET gently using a thin instrument.
If the RESET button is not pressed, the remote controller may not operate correctly.
Before operation: Insert the power supply plug into the power outlet and/or turn the breaker on.
Installing the remote controller batteries Setting current time
N
AME OF EACH PART
P
REPARATION BEFORE OPERATION
1.
Press CLOCK.
3.
Press CLOCK again.
2.
Press the TIME buttons to set
the time.
Each press increases/de-
creases the time by 1 minute
(10 minutes when pressed
longer).
Remote controller
1.
Remove the front lid.
2.
Insert the negative
pole of AAA alkaline
batteries fi rst.
3.
Install the front lid.
4.
Press RESET.
Remote controller
holder
Signal transmitting
section
Distance of signal :
About 6 m
Beep(s) is (are) heard
from the indoor unit
when the signal is
received.
Operation display
section
OFF/ON
(stop/operate)
button
Temperature buttons
Page 4
Battery replacement
indicator
Page 3
Operation
select button
Page 4
ECONO
COOL
button
Page 6
FAN speed
control button
Page 5
Off-timer button
Page 6
On-timer button
Page 6
VANE
control button
Page 5
TIME set buttons
Page 3, 6
Increase time
Decrease time
CLOCK button
Page 3
RESET button
Page 3
Lid
Slide down to open
• Install the remote controller
holder in a place where the
signal can be received by
the indoor unit.
Only use the remote controller provided with the unit.
Do not use other remote controllers.
If two or more indoor units are installed in proximity to one another, an indoor
unit that is not intended to be operated may respond to the remote controller.
i-save button
Page 5
Indoor unit
Air inlet (back and side)
Refrigerant piping
Drainage hose
Air outlet
Drain outlet
Outdoor unit
Outdoor units may be different in appearance.
Operation indicator lamp
Remote control receiving section
Air cleaning fi lter
(Anti-Allergy Enzyme
fi lter, option)
Air inlet
Air fi lter
(Nano platinum
fi lter)
Front panel
Air outlet
Heat exchanger
Emergency operation switch
Page 4
Horizontal vane
JG79Y270H02_en.indd 3 2017/04/28 13:32:59