Mitsubishi Electric MSH-GD80VB-E1, Руководство по обслуживанию

Страница: 24 / 26

24
DISASSEMBLY INSTRUCTIONS 11
MSH-GD80VB
NOTE: Turn OFF power supply before disassembly.
(1) Slide the sleeve and check if there is a locking lever or not. (2) The terminal with this connector has the locking
mechanism.
Slide the sleeve.
Pull the terminal while
pushing the locking
lever. Hold the sleeve, and
pull out the terminal
slowly.
The terminal which has the locking mechanism can be detached as shown below.
There are two types ( Refer to (1) and (2)) of the terminal with locking mechanism.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.
<"Terminal with locking mechanism" Detaching points>
Connector
Sleeve
Locking lever
1. Removing the panel
(1) Remove the screw caps of the panel.
Remove the screws of the panel.
(2) Pull the panel down to your side slightly and unhook the
catches at the top.
(3) Remove the screw of the corner box.
Remove the corner box.
Photo 1
Photo 2
Screw of the
corner box
Screw of the
V.A. clamp
Indoor
electronic
control
P.C. board
Vane motor
connector
Fan motor
connectors
Screws of the panel
Screw of
the electrical
cover
R.L
holder Screw of
the terminal
block
Receiver
P.C.
board
2. Removing the electronic control P.C. board, the receiver
P.C. board and the display P.C. board
(1) Remove the panel and the corner box. (Refer to 1.)
(2) Remove the screw of the electrical cover.
Remove the electrical cover.
(3) Remove the screws of the V.A. clamp.
Remove the V.A. clamp.
(4) Remove the screw of the terminal block.
(5) Remove the screws of the earth wire.
(6) Disconnect all the connectors and all the lead wires on the
electronic control P.C. board.
(7) Remove the R.L holder.
(8) Remove the electronic control P.C. board.
(9) Open the R.L holder, remove the receiver P.C. board and
the display P.C. board.
Screws of the earth wire
3. Removing the electrical box
(1) Remove the panel and the corner box. (Refer to 1.)
(2) Remove the electrical cover. (Refer to 2.)
(3) Disconnect the connector of the indoor coil thermistor.
(4) Disconnect the motor connector (CN211 and CN121) and
the vane motor connector (CN151) on the electronic
control P.C. board.
(5) Remove the screws of earth wire.
(6) Remove the fan motor lead wire and indoor coil thermistor
from the electrical box.
(7) Remove the lead wire of vane motor from the bottom of
electrical box.
(8) Remove the screw of the electrical box and remove the
electrical box.
Photo 3
Screw of the
electrical box
Screws of the earth wire
Screw of the
electrical cover
OPERATING PROCEDURE PHOTOS
OBH513A