Mitsubishi Electric Mr. Slim SLZ-M25, Руководство по эксплуатации

Страница: 11 / 19

11
3. Operation
* The draft reduction can be set for only 1 vane.
The setting is enabled only for the last vane that was set.
■
Manual vane angle (Wired remote controller)
A
B
Fig. 1
Fig. 2
Fig. 3
■
Con fi rmation procedure (wired remote controller)
Manual vane angle
Input display:
Cur. Address Check
Ref. address
Unit No.
Identify unit Check button
F1 F2 F3 F4
Manual vane angle
Return:
No communication
Check Unit state.
F1 F2 F3 F4
Manual vane angle
Return:
Ref. address
Unit No.
Function setting for unit
with vane fully open.
F1 F2 F3 F4
1
First, con fi rm by setting “Ref ad-
dress” to 0 and “Unit No.” to 1.
• Move the cursor to “Ref. address”
or “Unit No.” with the [F1] button
to select.
• Select the refrigerant address
and the unit number for the units
to whose vanes are to be
fi xed,
with the [F2] or [F3] button, and
press the [SELECT] button.
• Ref. address: Refrigerant address
• Unit No.: 1, 2, 3, 4
Press the [F4] button to con
fi rm
the unit.
2
Change the “Unit No.” in order
and check each unit.
• Press the [F1] button to select
“Unit No.”.
Press the [F2] or [F3] button to
change the “Unit No.” to the unit
that you want to check, and then
press the [F4] button.
• After pressing the [F4] button,
wait approximately 15 seconds,
and then check the current state
of the air conditioner.
→ The vane is pointing down-
ward. → This air conditioner is
displayed on the remote controller.
→ All outlets are closed. →
Press the [RETURN] button and
continue the operation from the
beginning.
→ The messages shown to the
left are displayed. → The target
device does not exist at this
refrigerant address.
• Press the [RETURN] button to
return to the initial screen.
3
Change the “Ref. address” to the
next number.
• Refer to step
1
to change the
“Ref. address” and continue with
the con
fi rmation.
1
Going to the Manual vane setting
mode
Press the button.
(Start this operation from the sta-
tus of remote controller display
turned off.)
“FUNCTION” is lighted and “1”
blinks. (Fig. 1)
Press the button to select “2”,
and then press the button.
2
Selecting the vane number (Fig.
2)
Press the buttons to select
the vane number
A
, and then
press the button.
3
Setting the vane angle (Fig. 3)
Press the buttons to select
the vane angle
B
.
Point the wireless remote control-
ler toward the receiver on the
indoor unit, and then press the
button.
Display
Setting Step 1 Step 2 Step 3 Step 4
Display No display
Setting Step 5 No setting Draft reduction*
VG79Y135H01_EN.indd 11 VG79Y135H01_EN.indd 11 10/15/2562 BE 9:14 AM 10/15/2562 BE 9:14 AM