EN
EN-10
7. Electrical work
Fig. 7-6
Fig. 7-5
B
C
D
E
Between ribs
A
Fig. 7-4
D
7.2.1. Installing the i-See sensor and signal receiver
Before installing the grille, connect the junction wires included with the grille acces-
sories and place them in the connector box.
1
Remove the two screws securing the wire cover of the main unit, and then open
the cover.
2
Route the wires of the i-See sensor and signal receiver through the wire inlets in
the electric component box as shown in the diagram and around the bushings on
the side of the main unit. (Fig. 7-4)
When routing the wires, open the clamp securing the grille junction wire, and then
secure the grille junction wire and the wires of the i-See sensor and signal receiver
with the clamp.
3
Remove the one screw securing the connector box cover, and then open the cover.
(Fig. 7-5)
4
Place the junction wire connector in the connector box.
5
Install the wire cover and connector box cover.
Caution:
When installing the covers, make sure that the wires do not get pinched.
Fit the band securing the junction wires between the ribs on the connector
box as shown in the diagram. (Fig. 7-6)
A
Wire cover
B
Connector box cover
C
Connector box
D
i-See sensor or signal receiver lead wire (Grille accessory)
E
Band
BH79A367W01_01En.indd 10
2018/05/30 9:17:44
