22
6-6. FUNCTIONS OF DIP SWITCH AND JUMPER WIRE
Each function is controlled by the dip switch and the jumper wire on control P.C. board.
Model setting and capacity setting are memorised in the nonvolatile memory of the indoor controller board.
The black square (
■
) indicates a switch position.
Setting by the dip switch and jumper wire
Functions
Jumper wire
Capacity
settings
Pair number
setting with
IR wireless
remote
controller
Remarks
SW2
J41
J42
Unit type
setting
JP1
0
1
2
3 ~ 9
Wireless remote
controller setting
Control PCB setting
J41
J42
<Initial setting>
IR wireless remote controller: 0
Control PCB: (for both J41 and J42)
Four pair number settings are supported.
The pair number settings of the IR wireless remote
controller and indoor control PCB (J41/J42) are
given in the table on the left.
(' ' in the table indicates the jumper wire is disco-
nnected.)
There is no jumper (JP1) because these models
have the cond./eva. temperature thermistor (TH5).
Jumper wire ( : Short : Open)
Without TH5
With TH5
Model
JP1
Setting
SLZ-KA09NA.TH
MODELS
ON
OFF
1 2 3 4 5
ON
OFF
1 2 3 4 5
ON
OFF
1 2 3 4 5
SLZ-KA12NA.TH
SLZ-KA15NA.TH
