
53
DISASSEMBLY PROCEDURE
9
OPERATING PROCEDURE
PHOTOS&ILLUSTRATIONS
1. Removing the air intake grille
(1) Press the PUSH button.
(2) Open the intake grille 90°.
(3) Remove the chip.
(4) Slide the shaft in the hinge to the left and remove the
intake grille.
PUSH button
Shaft
Intake grille
4. Removing the fan motor
(1) Remove the turbo fan nut and radiator aluminum cap.
(2) Pull out the turbo fan.
(3) Disconnect the connector of the fan motor lead wire.
(4) Remove the 3nuts of fan motor.
3. Removing the bell mouth (electrical parts)
(1) Disconnect the lead wire of the vane motor from the clamp,
and disconnect the red connector (8P).
(2) Remove 2 of 4 screws from the electrical parts box.
(3) Remove the electrical parts cover.
(4) Disconnect the following connectors from the box.
White (3P) for the fan motor
White (2P) for the pipe temperature thermistor
Blue (2P) for the drain pump
White (3P) for the drain sensor
(5) Disconnect the blue ground wire of the bell mouth.
(6) Remove 3 of 4 screws from the bell mouth, and loosen the
other screw.
(7) Pull out the bell mouth.
(Electrical parts inside the bell mouth)
Terminal block
power board
Indoor fan capacitor
Room temperature thermistor
Indoor controller board
Relay (PLH-P1.6/2/2.5/3/4/5/6KAH only)
2. Removing the electrical parts box.
(1) Open the intake grille.
(2) Remove the 4 screws of the electrical parts caver.
1. INDOOR UNIT
PLH-1.6KAH
Be careful on removing heavy parts.
Photo 1
Photo 2
Photo 3
Figure 1
Photo 4
Nut
Fan motor
Connector
screws
Lead wire for
vane motor
Screws
Box
cover
Clamp
Fan guard
Screws
Power board
Radiator
aluminum cap
Screws
Relay
Nut
Room
temperature
thermistor
Terminal
block
Connector
Screws
Indoor
controller board
Connector
Electrical parts box
Содержание Mr.Slim PLA Series
Страница 71: ......