Mitsubishi Electric Mr. Slim MSZ-FD09NA, Руководство по эксплуатации

Страница: 6 / 36

En-5
● OPERATING INSTRUCTIONS ●
P
REPARATION
BEFORE OPERATION
A
REA SETTING
Press to select AREA. Each press changes
AREA in the following order:
• The i-see control operation has to be active to select AREA.
• Horizontal airflow direction cannot be selected when AREA is
set.
*1 Horizontal airflow direction set by . Page 7
Press until “Cancel” is selected to release AREA
setting.
• Pressing also releases AREA setting.
Area
(AUTO) ....The i-see sensor detects temperature disparities, efficiently
cooling and heating the whole room.
(LEFT) / (RIGHT)
Select the desired area to be air conditioned.
Indoor unit display
Horizontal airfl ow direction:
Lighted Not lighted
Setting the installation position
Be sure to set the slide switch inside the remote controller in accordance with
the installed position of the indoor unit.
Installation position:
Left: Distance to objects (wall, cabinet, etc.) is less than 19-11/16 in. (50 cm)
to the left
Center: Distance to objects (wall, cabinet, etc.) is more than 19-11/16 in. (50
cm) to the left and right
Right: Distance to objects (wall, cabinet, etc.) is less than 19-11/16 in. (50 cm)
to the right
Area Left Center Right
Slide switch
Remote controller
display
Press during COOL mode to activate i-see control
operation.
• Press gently using a thin instrument.
• lights. (Operation display section)
Press again to release i-see control operation.
Slide switch
i-see control operation
The sensors constantly measure the room and
fl oor/wall temperature to automatically adjust to
the set temperature by estimating the tempera-
ture actually perceived by a person inside the
room (“sensible temperature”).
i-see sensor
When the AREA setting is not activated, the sensing range of the i-see sensor
differs depending on the installation location of the air conditioner.
Installation position Left Center Right
Sensing range
Floor/wall
temperature
43.7%
Room
temperature
30.9%
Humidity
20.7%
In COOL mode:
Daytime Nighttime
Warm area Cold area
Left Right Center or Swing
Cancel
(AUTO) (Left) (Right) *1
Note:
Do not touch the i-see sensor. This may cause malfunction of the i-see sensor.
(Left) (Center) (Right)
SG79F214H03_En.indd 5 2008/11/12 14:23:55