19
Troubleshooting
Resetting the CLEAN FILTER
lamp
Silver Ion Filter, Air Intake, and Sensor
Clogging with dust and the like reduces the effectiveness of the dehumidifying.
Clean once every two weeks
Removing and setting the fi lter, see P8
1
Insert the power plug in
a power socket.
2
Press the RESET switch
until you hear a beep
(for approximately 3
seconds).
Press
until you hear a
beep.
Once every two weeks or when the CLEAN FILTER lamp fl ashes or lights
Remove any dust from the white net surface with
the nozzle of a vacuum cleaner.
Do not use a nozzle with a brush. This may
damage the fi lter.
<When the fi lter is very dirty>
Soak the fi lter in water.
Remove the fi lter cover.
Clean the fi lter.
Clean the air intake and
sensor.
4
Remove any dirt
with a vacuum
cleaner.
Do not use a nozzle with a brush.
This may damage the fi lter.
Set the silver ion fi lter into
the fi lter cover.
5
Make sure the silver ion fi lter is attached to
the unit. If it is not, fi ne dust will enter inside
the unit and cause a malfunction.
Set the fi lter cover.
6
Press the POWER switch to turn off the
power, wait until the blower fan stops rotating
(approximately 2 minutes) before unplugging the
power cord.
Remove the silver ion fi lter
from the fi lter cover.
1
3
2
P20
Sensor
Air intake
E
e̲mj̲ez6cx̲s1.indb 19
e̲mj̲ez6cx̲s1.indb 19
2010/05/17 10:28:16
2010/05/17 10:28:16
