1
Remove the pre-filter.
2
Remove the photocatalytic filter.
3
Soak the photocatalytic filter in
water.
¡
Stains may remain on the filter, but should not
affect performance.
¡
The filter can be soaked for a total of eight
times.
After that, replace with a new filter.
24
24
Maintenance (Continued)
Once every three months
Photocatalytic filter
Soaking the filter in water
, and leaving it to dry in the sun
renews the performance and prolongs service life. Perform
this every three months.
4
Dry the photocatalytic filter.
Dry well in the sun (The
performance of the filter
renews with soaking, and
the photocatalytic effect
of the sunlight removes
remaining odorants)
5
Fit the photocatalytic filter.
With the strips facing up, set the
photocatalytic filter inside the tabs
on the pre-filter.
6
Attach the pre-filter.
Soak in cool to
lukewarm water for
30 minutes.
Do not use detergent or hot water.
Also, do not brush or rub while
soaking as this may damage the filter.
Do not hang with pegs as this may
damage the filter.
Do not use the filter while wet.
Insert the bottom tabs into the unit until they
click.
Pull forward to
remove.
Performance is unaffected even if the metal fins
inside the main unit are slightly bent.
Tabs (4)
Strips
e_mj_e26vx_a1(20_28)_e33.qx 05/10/13 5:23 PM Page 24
