40
2. Removing the electronic control P.C. board and the
display and receiver P.C. board
(1) Remove the panel. (Refer to 1.)
(2) Remove the screw of the electrical cover, and then the
electrical cover.
(3) Remove the screw of the earth wires under the electrical
box, and then the earth wires.
(4) Remove the screw of the earth wires connected to the
indoor fan motor (lower), and then the earth wires.
(5) Remove the screw of the earth wires connected to the
indoor heat exchanger, and then the earth wires.
(6) Unhook the lamp cover from the catch.
(7) Open the lamp cover and pull out the display receiver P.C.
board.
(8) Remove the screw of the earth wires connected to the
electronic control P.C. board, and then the earth wires.
(9) Pull the electronic control P.C. board slightly toward you
from the electrical box, and disconnect all the connectors
on the electronic control P.C. board.
(10) Pull out the electronic control P.C. board from the electri-
cal box.
OPERATING PROCEDURE
PHOTOS
Screw of the
electrical box
Screws of the
earth wires
Photo 4
3. Removing the electrical box
(1) Remove the panel. (Refer to 1.)
(2) Remove the electrical cover. (Refer to 2.)
(3) Remove the earth wires from the electrical box. (Refer to 2.)
(4) Remove the earth wires connected to the indoor fan motor
and the ones connected to the indoor heat exchanger.
(Refer to 2.)
(5) Remove the screw of the electrical box.
(6) Disconnect the following connectors on the electronic con-
trol P.C. board.
• Fan motor connectors < CN211, CN212 >
• Horizontal vane motor connector < CN151 >
• Damper motor connector < CN152 >
•
Display receiver P.C. board connectors < CN106, CN125 >
• Indoor coil thermistor connectors < CN112, CN113 >
• Room temperature thermistor connector < CN111 >
• Damper limit switch connectors < CN1X1, CN1Y1 >
(7) Unhook the electrical box from the upper catch and pull
out the electrical box from the box.
Photo 5
Display receiver
P.C. board connec-
tor CN125
Indoor coil thermistor
connector CN113
Fan motor
connector CN212
Photo 3
Display receiver
P.C. board connec-
tor CN106
Screw of the
electrical cover
Horizontal vane
motor connector
CN151
Damper motor
connector CN152
Fan motor
connector CN211
Lamp cover
OB409E