Mitsubishi Electric MELSEC iQ-R RD75P4, Руководство пользователя

Страница: 490 / 598

488
12 DATA USED FOR POSITIONING CONTROL
12.12 Parameter Reflection
12.12
Parameter Reflection
The parameters of the RD75 are classified into the module parameter and module extension parameter.
The parameters are stored in the CPU module or the RD75 as a module parameter file and module extension parameter file.
*1 For the reflection timing of parameters, refer to the following.

Page 488 Parameter storage destination and reflection timing
*2 "Memory Card Parameters" of the CPU module determines whether the parameter file in the CPU module is used or the parameter file
in the SD memory card is used.
Parameter storage destination and reflection timing
The following table lists the parameter storage destinations.
*1 The storage destination differs depending on the extension parameter storage setting. For details, refer to the following.

Extended parameter storage setting
(1) Select a write destination (CPU module or RD75) with "Write to PLC".
(2) "Extension parameter storage setting" determines whether the file in the CPU module is used or the file in the RD75 is used.
(3) The power is turned on or the CPU module status is changed from STOP to RUN.
(4) The power is turned on.
Parameter file Parameter Storage destination
Type Item
Module parameter file Module parameter Basic setting Basic parameter 1, 2
Detailed parameter 1, 2
OPR basic parameter
OPR detailed parameter CPU module
Application setting CPU error output mode setting
Interrupt setting Parameters for the Interrupt setting
Module extension
parameter file Module extension
parameter Positioning data Positioning data CPU module or RD75
*1
Block start data Block start data
Condition data
RD75
GX Works3
(1)
(2)
(4)
(3)
Flash ROM
Buffer memory
CPU module
*2
Write to PLC
Reflect the
parameter.
*1
Module extension
parameter
Module parameter file
Module extension
parameter file Module extension
parameter file
Module parameter
Others