7
6. Connecting the M-NET Interface, the Power Supply, and the ME Remote Controller
• When connecting the unit to a system controller or ME Remote Controller, connect the transmission line of the M-NET to the
control signal terminal.
Connect the 2-core connection wrings
A
to A1/B1 or A2/B2 (they can be connected to either).
• Cross the shield portion of each connecting wire using the S terminal only when cross wiring the connection wires.
• When connecting the connection wrings
A
and the ME Remote Controller connection wrings
B
to the terminal board, there is
no need to worry about polarity.
When the connection wrings
A
are not cross-wired
When the connection wrings
A
are cross-wired
1
Shield
2
Connection wirings
A
(M-NET transmission wire)
3
ME Remote Controller
(only when needed)
Bare wire size
• After the wiring is completed secure the ires with the cord clamp (large) and the cable ties.
1
Screws
2
Cord clamp (large)
3
Cord clamp (small)
Caution
•
Electrical work should be performed in accordance with the Technical Standards Regarding Electrical Equipment
and the Interior Wiring Standards.
•
Connection wiring and remote control wiring should be located as far away from other electrical wiring as possible.
Placing them too closely together could cause a malfunction.
When the connection wring
A
is cross-wired
A1 B1 A2 B2
S
2
3
A1 B1 A2 B2
S
2
2
3
1
When using the ME remote controller
When the connection wring
A
is not cross-wired
1
4
2
1
5
4
1
2
4
3
1
4
2
4
Cable ties
5
Cut with nippers at the notches.
Make sure the cut surface is free of any burr so that the
connection wire dose not get damaged.
