D
Relationship between the rotating
hook motion and the thread take-up
lever motion
When the timing belt is removed for replacement,
etc., the relation between the rotating hook motion
and the thread take-up lever motion should be
adjusted as follows:
( 1 ) Turn the pulley and stop when the thread
take-up lever is lifted to the highest position.
( 2 ) Lean the machine head backward and check
that the arrow (timing mark) put on the
timing belt is aligned with the black line on
the boss of lower shaft bearing.
( 3 ) If the timing mark is not in line with the
black line, remove the timing belt and install
it again to adjust.
E
Relationship between the rotating
hook motion and the opener motion
( 1 ) Turn the pulley by your hand and stop it
at the position where the opener holder is
located most remotely from the throat plate.
( 2 ) Check that the gap between the lug Ⓐ and
the opener is approximately 0.2mm.
( 3 ) If the gap is too large or small, loosen the
opener holder screw Ⓑ and adjust position of
the opener.
HOW TO USE
Timing belt pulley
Timing mark (arrow)
Black line on boss of lower shaft bearing
Timing belt
Approx. 0.2mm
Opener
Opener holder
Ⓐ
Screw
Ⓑ
— 10 —
