Mitsubishi Electric GOT SIMPLE Series, Руководство пользователя

Страница: 41 / 310

5 EMC DIRECTIVE
5.1 Overview
39
5
5
EMC DIRECTIVE
5.1
Overview
For the products sold in European countries, the conformance to the EMC Directive, which is one of the European Directives,
has been a legal obligation since 1996.
Manufacturers, who recognize that their products comply with the EMC Directive must declare that their products comply with
the Directives and put a CE mark on the products.
Sales representative in Europe
The sales representative in Europe is as shown below.
Company name: Mitsubishi Electric Europe BV
Address: Mitsubishi-Electric-Platz 1, 40882 Ratingen, Germany
Conforming standards in the EMC Directive
The GOT complies with the following standards in the EMC Directive.
*1 The GOT is an open type device (designed to be integrated in equipment).
Make sure to install the GOT on a control panel.
This test item is conducted in the condition where the GOT is installed on a control panel and combined with the MITSUBISHI PLC.
*2 QP: Quasi-peak value, Mean: Average value
*3 This test item is conducted in the following conditions.
· 30 MHz to 230 MHz
QP: 40 dB
μ V/m (measured at 10 m)
· 230MHz to 1000MHz
QP: 47 dB
μ V/m (measured at 10 m)
Applied
standard Test standard Test details Standard value
EN61131-2: 2007 CISPR16-2-3
Radiated noise
*1
Test for measuring electromagnetic emissions
from the product • 30 MHz to 230 MHz
QP: 30 dB μ V/m (measured at 30m)
*2*3
• · 230MHz to 1000MHz
QP: 37 dB μ V/m (measured at 30m)
*2*3
IEC61000-4-2
Electrostatic immunity
*1
Immunity test in which static electricity is
applied to the cabinet of the equipment • Contact discharge: ±4 kV
• Aerial discharge: ±8kV
IEC61000-4-3
Radiated electromagnetic field,
amplitude modulation
*1
Immunity test in which an electric field is applied
to the product 80 MHz to 1000 MHz: 10 V/m
1.4GHz to 2GHz: 3V/m
2.0GHz to 2.7GHz: 1V/m
(80% amplitude modulation at 1 kHz)
IEC61000-4-4
Fast transient burst noise
*1
Immunity test in which burst noise is applied to
the power cables and the signal lines Power cable: 2 kV
Digital I/O: 1 kV
Analog I/O: 1 kV
Signal cable: 1 kV
IEC61000-4-5
Surge immunity
*1
Immunity test in which lightening surge is
applied to the product • DC power type
Power cable (between cable and ground): ±0.5 kV
Power cable (between cables): ±0.5 kV
Data communication port: ±1kV
IEC61000-4-6
Conducted RF immunity
*1
Immunity test in which a noise inducted on the
power cable and the signal lines is applied Power cable: 10V
Data communication port: 10V
IEC61000-4-8
Power supply frequency magnetic
field immunity Test for checking normal operations under the
circumstance exposed to the ferromagnetic field
noise of the power supply frequency (50/60 Hz) 30 A/m