Easy Start Guide
14. How to reset the Inverter to Factory Defaults
Page 14
This guide has been produced by The Inverter Drive Supermarket Ltd.
All content, including but not limited to graphics, text and procedures copyright
The Inverter
©
Drive Supermarket and must not be reproduced or altered without prior written permission.
14.1 Select “PU” operation mode.
With the motor stopped, press the “PU/EXT” key
repeatedly to cycle through operation modes until the
“PU” indicator is illuminated and “0.00" is displayed.
Note: This ensures that the control mode is set to
“Parameter Unit” ie. the motor is controlled using the
integrated keypad on the front of the Inverter.
14.2 Change mode to “Parameter setting”.
Press the “MODE” key repeatedly until the “PRM”
indicator is illuminated. The display will show “P. 0” as
shown opposite.
Note: The display may show the last selected parameter
instead of “P. 0”.
14.3 Select the “ALLC” parameter.
Use the dial to scroll through the parameters to “ALLC”.
Press the “SET” key to select parameter “ALLC”. The
display will show the initial parameter value of “0".
14.4 Change the parameter value from 0 to 1 and set.
Use the dial to change the value to “1" and press “SET”.
The display will flash between “ALLC” and “1". Press the
“SET” key again to confirm. If the display flashes “Er4"
ensure that the “PU” operation mode has been selected.
The display will return to the initial parameter value of “0".
Press the set key again to return to the parameter list.
The next parameter in the list “Er.CL” will be displayed.
All parameter values have now been reset.
Mitsubishi D700-SC Series Inverter
