– 17 –
2-4. Test Run
To run a test, follow the procedure below.
(1) Touch the Test Run button on the Service Menu screen to access the Test Run screen.
(2) Touch the OFF(ON) button (labeled
1
in the figure) to run a test on the group.
Test Run screen
Test Run Advanced setting screen
(3) During the test run, verify that air conditioned air is blowing out of the supply air outlet.
(4) After checking for normal operation of each unit, stop the units through AT-50B or the local remote controllers.
* Refer to the unit installation manual for the detailed information about test run.
1
OFF(ON)/Test Run
Touch the OFF(ON) button to start a test run.
Touch the Test Run button to stop the test run.
(These buttons are active only for the units that
support the test run function.)
* If
is displayed at the left top of the button, it
indicates that the group is Air To Water (PWFY) group.
2
Operation mode
Touch this button to switch the operation mode.
3
Pipe temperature
*1
The pipe temperature of the unit with the lowest
address in a given group will appear.
4
Advanced settings
Touch this button for advanced settings.
*1 The water temperature will appear if the group is Air To Water (PWFY) group.
The water temperature to be displayed depends on which temperature sensor is
selected on Air To Water (PWFY) side.
Display
Function
A
Indoor temperature
*2
Indoor air temperature will appear.
B
Unit address up/
down arrows
Use the up/down arrows to select the unit whose
pipe temperature you want to check.
C
Pipe temperature
*1
The pipe temperature of the unit whose address is
shown on the screen will appear.
D
Remaining time
The remaining time for the test run will appear.
*1 The water temperature will appear if the group is Air To Water (PWFY) group.
*2 Indoor temperature will not appear if the group is Air To Water (PWFY) group.
3
4
2
1
A
D
C
B
WT06990X04_GB.book 17 ページ ２０１８年５月２２日 火曜日 午後１時５５分
