Mitsubishi Electric 800 Series, Инструкция по эксплуатации, Страница: 356 / 727

(M) Monitor display and monitor output signal
PARAMETERS
355
5
GROUP
M
 Minus sign display for the monitors (Pr.290)
• A negative output can be selected for the monitor display of the terminal AM (analog voltage output), the operation panel,
and a communication option. For a list of the monitors that can output values with minus signs, refer to the monitor
description list (on
page 348 ).
• Negative output is available for FR Configurator2 or the trace function.
—: Disabled (unsigned numbers only)

The following communication does not support the negative output.
RS-485 communication (Mitsubishi inverter protocol, MODBUS RTU), SLMP communication, and HMS network option

Under the condition that the high-speed sampling and the negative output are selected for FR Configurator2, the display range of the output
frequency (Monitor No.1) is -300.00 Hz to 300.00 Hz. A value outside the range is clamped at -300.00 Hz or 300.00 Hz. Under the same
condition, the display range of the running speed (Monitor No.6) is -30000 r/min to 30000 r/min. A value outside the range is clamped at -30000
r/min or 30000 r/min. During the trace sampling, the same display ranges are applied. A value outside the ranges is clamped.
• Select items to be displayed with minus signs using Pr.1018 Monitor with sign selection .
○ : Displayed with minus signs, —: Displayed without minus signs (unsigned numbers only)

Displayed without minus signs on the operation panel. Confirm the rotation direction with the [FWD] or [REV] indicator.

Signed values are displayed only on the FR-DU08 (-9999 to 9999). Unsigned values (0 to 9999) are displayed on other devices.

Full 32-bit data (-2147483648 to 2147483647) is displayed during monitoring via the communication option.

Monitor the lower and upper digits at the same timing. Otherwise, the data may not be reliable.
Pr.290 setting
Connection port
Terminal AM Operation panel Communication option

FR Configurator2 etc.

0 (initial value) — — — —
1 Enabled — — —
2 — Enabled — —
3 Enabled Enabled — —
4 — — Enabled Enabled
5 Enabled — Enabled Enabled
6 — Enabled Enabled Enabled
7 Enabled Enabled Enabled Enabled
Monitor item
Pr.1018 setting
9999 0 1
Output frequency —
○

○

Motor speed —
○

○

Motor torque
○ ○ ○
Position command (lower)

○

○

○

Position command (upper)

○

○

○

Current position (lower)

○

○

○

Current position (upper)

○

○

○

Droop pulse (lower)

○

○

○

Droop pulse (upper)

○

○

○

Torque command
○ ○ ○
Torque current command
○ ○ ○
Torque monitor (power driving / regenerative driving
polarity switching)
○ ○ ○
Motor temperature
○ ○ ○
PID deviation
○ ○ ○
Cumulative pulse
○ ○ ○
Cumulative pulse overflow times
○ ○ ○
Cumulative pulse (control terminal option)
○ ○ ○
Cumulative pulse overflow times (control terminal option)
○ ○ ○
Remote output 1
○ ○ ○
Remote output 2
○ ○ ○
Remote output 3
○ ○ ○
Remote output 4
○ ○ ○
PID manipulated amount
○ ○ ○
Second PID deviation
○ ○ ○
Second PID manipulated amount
○ ○ ○
Control circuit temperature
○ ○ ○