Mitsubishi Electric 742 Series, Основное руководство пользователя

Страница: 26 / 44

26
3. TV Features
For assistance call 1(800) 332-2119
Sound Projector, continued
Auto Setup
Auto setup uses a calibration microphone to optimize
Sound Projector performance for most room condi-
tions.
Initial Preparation
1.
Position and connect the TV as described under
“Before You Begin” on the previous page.
2.
Power on the TV and external subwoofer, if any.
3.
Plug the microphone cable into the TV’s INPUT 1 left
(white) audio jack.
3D
GLASSES
EMITTER
ANT
DIGITAL
AUDIO
OUTPUT
AUDIO/SURROUND
-OUTPUT- R L
LAN
CENTER
INPUT
SUB WOOFER
OUTPUT
USB-P
1 2
3 4
HDMI
L
R
TV jack panel
L
R
L
R
DIGITAL
AUDIO
OUTPUT
Connect microphone to the
left (white) audio input jack.
4.
Place the microphone as described in the guide-
lines on the previous page.
Start Auto Setup
5.
Press
MENU
and go to
Sound > AutoSP.
6.
Highlight
START
and press
ENTER
.
7.
Quietly exit the room right away. The calibration
sequence will start in a few seconds and may be
loud. It is important to leave the room as your pres-
ence will interfere with the calibration process.
8.
Wait for completion of setup before returning
to the room.
9.
Play some sample audio material to check the
sound quality.
Note: Do not perform manual adjustments after run-
ning Auto setup, as this will erase all settings
defined during Auto setup.
10.
Store the microphone out of direct sunlight and
away from heat.
Basic Manual Setup
Note:
If you have already performed Auto setup, do
not make manual adjustments. Doing so will
erase all settings created during Auto setup.
1.
Press
MENU
and go to Sound > SoundPro.
2.
Enter the room dimensions and layout information
requested in the screen. To change measure-
ments, press or enter numbers on the remote
control’s keypad.
3.
Press
EXIT
to exit and save settings.
4.
Play some sample audio to check sound quality.
If further adjustment is needed, use the
Custom
menu as described next.
Custom Menu
Use the
Custom
menu after defining the room layout.
For a room with large areas of curtains that might affect
sound reflection, do the following:
a. Open the curtains fully to improve sound reflec-
tion.
b. Set angles by performing the procedure in
“Adjusting Beam Angles.”
c. Close the curtains.
d. Set levels by performing the procedure in
“Adjusting Levels.”