5
ASSEMBLY OF THE BRUSH CUTTER
The blade fitted to the guard is sharp and can cause injury, always wear gloves
INSTALLATION OF THE GUARD
•
Place the brush cutter with the head facing down.
•
Fit the shield using the bracket and 3 X M5x16 screws Fig1 & Fig 2.
INSTALLATION OF THE NYLON HEAD
•
Lay the brush cutter on its back with the gearbox shaft facing up.
•
Rotate the gearbox shaft until the hole in the holder A lines up with the slot in the plastic guard Fig 3.
•
Insert the Allen key into the hole in the gearbox cover and into holder A Fig 4.
•
Screw the nylon head anti-clockwise (turn left) Fig 5 onto the threaded shaft on the end of the gearbox.
•
Make sure that the nylon head is securely locked in position.
•
Remove the Allen key.
Fig1
Fig
2
Fig 3
PLASTIC GUARD HOLDER A
Fig 4
ALLEN KEY
Fig 5
SCREW THE HEAD ANTI-CLOCKWISE
