STEELCLUB Irons Angle Machine
1. Clean occasionally with WD-40 to prevent corrosive build up.
2. Face Tape: As needed, clean off old tape on backside of Face Fixture and replace
with two new pieces of tape, cut approximately 2 1/2” long from the roll. Peel the
back off the tape and place on the backside of Face Fixture, directly above the Iron
Sole Clamps. Make sure tape is pressed on evenly by rubbing with a hard object,
such as a coin.
3. Keep a small amount of grease on the bottom end of the Top Worm Screw where it
makes contact with the Top Clamp.
4. Occasionally apply grease to the Top Worm Screw.
Call 1-800-437-1314
Monday-Friday 8:00AM-5:00PM Eastern Time
Email: [email protected]
