2
Important Safeguards
When using this electrical appliance,
the following basic safety precautions
should always be followed:
For Your Safety
• Voltage: Make sure your outlet voltage and
circuit frequency correspond to the voltage
stated on the appliance rating label. If it does
not match, contact our after sales support
line and do not use the appliance.
• Connection: Insert the plug properly into an
earthed mains socket. Make sure the socket
is within easy reach so the plug can easily be
removed if necessary.
• Electrical circuit: To avoid an electrical
circuit overload do not use a high wattage
appliance on the same circuit with the
Airfryer Oven.
• Do not immerse: To protect against electric
shock, do not immerse the cord, plug or the
electric base in water or other liquid. If the
base is accidentally immersed, immediately
unplug the power plug, dry the appliance
and have it checked by qualified service
personnel.
• Protect from moisture: Do not expose the
electrical connections to water. Do not use
the appliance, or touch the plug, with wet or
damp hands, on a damp floor or when the
electric base is wet.
• Power cord: A short power supply cord is
provided to reduce the hazards resulting from
becoming entangled in or tripping over a
longer cord. However, if an extension cord
must be used, make sure its marked electrical
rating is the same as the product. Arrange
the extended cord so it will not drape over
the table or benchtop where it can be pulled
on or tripped over accidentally. Do not kink,
bend, squash, strain or damage the power
cord and protect it from sharp edges and
heat. Do not let the cord hang over the edge
of a table or benchtop, or touch hot surfaces.
• Damage: Check the power cord regularly
for visible damage. If it is damaged, it
must be replaced by the manufacturer, its
authorised service centres or similarly qualified
personnel in order to avoid any hazards.
Do not pick up or operate an appliance
with a damaged cord or plug, or after the
appliance malfunctions or has been dropped
or damaged in any manner.
In case of damage, call our after sales
support line for advice on repair or return of
the damaged product.
• Unattended: Do not leave the appliance
unattended when plugged in.
• After use: Unplug the appliance after use.
Wait until it has cooled completely before
attempting to move or clean it.
• Disconnect: Always unplug the power cord
when the appliance is not in use. When
unplugging the appliance, grip by the plug,
do not pull by the cord.
• RCD: Unless your home is already fitted with
a residual current device (safety switch), we
recommend installing an RCD with a rated
residual operating current not exceeding
30mA to provide additional safety protection
when using electrical appliances. See your
electrician for professional advice.
Caution: Hot Surfaces!
• The Airfryer Oven and accessories will
become very hot during use. Do not come
into contact with heated parts while or
after using the Airfryer Oven! Only touch the
handles and control knobs while the Airfryer
Oven is in operation or immediately after it
has been switched off. The appliance needs
approximately 30 minutes to cool down. Wait
until the Airfryer Oven has cooled down fully
before it is transported, cleaned or stored
away. Use oven gloves and the rotisserie
removal tool if necessary when handling the
hot accessories.
• Open the door! Take care when opening the
door! There is a danger of scalding from hot
steam.
• Free space: Do not place the appliance
against a wall or against other appliances.
Hot air up to 160 Degrees expels through the
rear vent of the appliance.
Leave at least 10cm clearance around the
entire appliance , including directly above
it. Additional care should be taking when
placing appliances on bench top surfaces
or near splash backs where such materials
(Acrylics , timber etc. ) do not have the high
heat resistant properties , so advise to place
them on top of a heat resistant material
between bench and appliance and further
away from wall surfaces / splash backs.
• Safe distance: During hot air frying, hot steam
is released through the air outlet openings.
Keep your hands and face at a safe distance
from the steam and form the air outlet
openings.
