10.
Install stabilizers (20) in desired locations as shown in
Fig. 10 using 1/4” - 20x1.5 screws (21), 1/4” flat washers (22),
1/4” - 20 nuts (23).
Loading & Securing Bikes on Carrier
Place bikes in troughs on the mounting plates, alternating
directions of handlebars. Slide bike on mounting plates so
vertical tube of bikes’s frame will fit in stabilizer slot.
It is recommended to place heavier bikes closer to vertical
tube to maximize ground and trailer clearance
.
Once bikes in desired position on mounting plate pull rubber
strap over bikes frame and secure to tab on the mounting
plate.
It is recommended to secure straps on tabs of the mounting
plate when they are not in use.
Use large holes in mounting plates for cable locks.
To tilt bike carrier, remover hair pin and hitch pins. Then tilt
carrier away from vehicle. Work same way to fold top support.
After folding top support can be locked in folded position
using same pins. Folding and tilting are shown on the front
page.
DO NOT TILT BIKE CARRIER OR FOLD SUPPORT WITH
BIKES MOUNTED! DO NOT TILT BIKE CARRIER WITH
Towing Instructions
When towing observe the following safety precautions.
1. Do not overload, maximum Camper/Trailer G.T.W.
1600kg, T.W. 160kg (Tow Ball not included)
2. Provide enough clearance between bikes and Camper/
Trailer. If necessary remove or fold trailer accessories
such as jacks, tool boxes to create additional space for
bikes.
Special Installations
For some vehicles special installation is necessary.
To increase clearance between rear bumper and bike carrier,
rotate angle plates (6) so vertical tube will be installed farther
from rear bumper.
Parts Guide
WARRANTY
PAGE 4
WARNING: NOT SUITABLE FOR OFF ROAD USE
USE TIE DOWNS FOR ADDED SAFETY. DO NOT OVERLOAD BIKE CARRIER
OR TOW HITCH
Содержание MHBC4F
Страница 1: ...PAGE 1 ...
