CLEANING AND MAINTENANCE
1. Clean the product in time after using.
2. Please unplug the power plug before cleaning the product.
3. When cleaning, the main body and the pitcher should be cleaned separately.
4. For the main body, you can use a wet cloth with neutral detergent, and then wipe it with a dry
cloth.
5. The lids can be rinsed directly and soaked. Clean with a dry cloth after cleaning and let dry
naturally.
6. For the pitcher, please use a sponge, clean brush or cloth to clean, then put them upside
down to dry, and put them in a dry place.
Tips:
If it is difficult to clean the residue at the bottom of the cup, add some warm water into,
wait until the residue become soft, brush it in the same direction with a cleaning brush, and then
rinse it with clean water.
Do not clean or soak the main body or the base of pitcher in water.
Be careful with the blades. It is very sharp.
7. Make sure all parts of the vacuum blender have dry completely before storing and please
store in a dry place, away from direct sunlight.
TROUBLESHOOTING
Fault
Reason
Solution
Not working
The device is not connected
to a power source.
Chech the device if it is not connect to the
suitable power source.
The pitcher is not installed
on the main body properly.
Reinstall the pitcher so that it
fits the joints on top
of the body.
Not install the inner lid or the
outer lid.
The lids should be installed to the pitcher before
operating.
Peculiar smell
in the first use
The smell is scattered from
the rubber surface of the
main engine, because the
product is designed with
super wear-resistant
material, which plays the
role of fixing the cup body,
shock absorption and noise
reduction.
After several times of use, it will be tasteless. It is
recommended to put it in a ventilated place.
Food cannot
be broken
The voltage is too low or part
of the village voltage is
unstable.
Select the electrical environment corresponding
to the rated voltage of the machine and stabilize
the voltage.
Too few or many ingredients. Stop the machine and adjust the ingredients.
Water shortage.
Please follow the minimum water level
Liquid overflow Too much water.
Please follow the maximum water level
E1 displayed
Open circuit.
Contact to the customer service center.