MIRKA airos MIA6514112, Электрическое руководство

Страница: 8 / 48

Description Indicator
Possible tool wiring fault. Turns red when a possible fault in tool C+/C–/P+/P– wiring is detected. D36
Speed set-point display
BIT 1
D2
BIT 2
D3
BIT 3
D17
BIT 4
D18
BIT 5
D19
BIT 6
D20
BIT 7
D21
BIT 8
D22
RPM
ON OFF OFF OFF OFF OFF OFF - ≥ 4,000
ON ON OFF OFF OFF OFF OFF - ≥ 5,000
ON ON ON OFF OFF OFF OFF - ≥ 6,000
ON ON ON ON OFF OFF OFF - ≥ 7,000
ON ON ON ON ON OFF OFF - ≥ 8,000
ON ON ON ON ON ON OFF - ≥ 9,000
ON ON ON ON ON ON ON - ≥ 10,000
Modbus RTU slave address display
BIT 1 BIT 2 BIT 3 BIT 4 BIT 5 BIT 6 BIT 7 BIT 8
D2 D3 D17 D18 D19 D20 D21 D22
Jumper description
Description Default Jumpers
Reserved for future use Not set JP1
If set, a terminating resistor of 270 Ω is connec-
ted across Modbus RTU pins A and B. Not set JP2
If set, a pull-down resistor of 10 kΩ is connec-
ted to Modbus RTU B-pin. Not set JP3
If set, a pull-up resistor of 10 kΩ is connected
to Modbus RTU A-pin. Not set JP4
If set, digital speed control feature is enabled. Not set JP12
If set, D2–D3, D17–D22 indicators will output
the current Modbus RTU slave address instead
of speed set-point. Not set JP13
Reset to factory settings. Not set JP15
Tool cable connector pinout
Description Pin (colour, size)
Not in use PE (green–yellow,
1.0 mm2)
Phase A 1 (brown, 1.00 mm²)
Phase B 2 (blue, 1.00 mm²)
Phase C 3 (black, 1.00 mm²)
C- A (grey, 0.25 mm²)
C+ B (pink, 0.25 mm²)
P– C (green, 0.25 mm²)
NTC– C (yellow, 0.25 mm²)
NTC+ D (brown, 0.25 mm²)
P+ E (white, 0.25 mm²)
NOTE! NTC– and P– are connected together to the same PIN inside the connector.
8
en (original)