Mircom DACT-100A, Инструкция по установке и эксплуатации

Страница: 8 / 20

Page 6
Enter 4-6 digit ID#
Account ID: _ _ _ _ _ _
Press <#> when done
or <*> to cancel.
Enter 31 to input the area code (prefix code) of telephone line 1. The following screen will appear,
First digits to dial
Prefix Code: _ _ _
Press <#> when done
or <*> to cancel.
Enter 32 to input the telephone number of line 1. The following screen will appear,
Local number to dial
Telephone #: _ _ _ _ _ _ _
Press <#> when done
or <*> to cancel.
Repeat step 11 for the second telephone line by entering Item numbers 40 and 41.
12. Set the Format to be generated by the DACT when reporting to the monitoring station for both telephone lines.
Enter 33 for Telephone Line 1 Enter 43 for Telephone Line 2
1=SIA, 2=Contact ID 1=SIA, 2=Contact ID
Format is: _ Format is: _
Press <#> when done Press <#> when done
or <*> to cancel. or <*> to cancel.
13. Enter 11 to initiate the test report, the screen will go through the following sequences:
Digital Communicator
[Testing Line DC]
Date Time
Press any key to start login procedure (scrolls horizontally)
If it stays in the testing line DC screen, then the polarity of the phone line may be reversed, the phone line is not
operating properly or the DACT-100A is not the first piece of equipment on the telephone line. If the telephone line is
good, the next screen should be,
Digital Communicator
[Wait for DIALtone]
Date Time
Note: It will wait for dial tone if selected as such, see Item 63 in System Configuration & Operation section.
If the screen stays in the Wait for Dialtone mode, then there is a telephone line failure, otherwise the next screen is,
Digital Communicator
[Dialling Station . . .]
Date Time