www.CondoSecure.com
Typical Use
When leaving
Press the Arm button on the keypad.
The Arm light will flash. You must leave before the end of the Exit
time programmed (45 seconds when 1
st
installed).
Upon returning
The keypad will beep to remind you to enter your 4-digit disarm code.
You must do this before the end of the Entry time programmed (45
seconds when 1
st
installed) or you will cause an alarm at the security
desk.
After entering your 4 digit Disarm code, look at the Status light. If the
Status light is ON
steady
(not flashing) it is telling you that there was
an alarm while you were out. YOU MUST ENTER YOUR 4 DIGIT
CODE AGAIN TO CLEAR THE MEMORY. THE KEYPAD WILL
NOT ARM AGAIN UNTIL THE MEMORY IS CLEARED THIS
WAY.
Instant Arming
Press the Arm button twice. The Arm and Inst lights will come on. Do
not open your suite door or you will cause an alarm. There is no
Entry/Exit delay.
To leave your suite or even to open the door to get the morning
newspaper, enter your 4-digit disarm code. Both lights will go out. If
you are leaving, press the Arm button
once
to re-arm the keypad with
the Exit delay this time. You may now open the door to leave.
Changing the Master Code
Press ‘
77
’ then enter your current code.
The unit will make one long beep.
Enter four new numbers.
Press ‘
ARM
’ to enter or press ‘
EMERG
’ to cancel.
If a correct code is entered and set the unit will emit 2 long beeps. (1 if
canceled)
NOTE: this must be completed within 60 seconds or the command will
cancel automatically.
