3
2.2.3 imaging Solo Frame
To install this module into Solo follow these steps. For a closer look at module installation and
removal, refer to the frame's Guide to Installation and Operation.
1. In order to remove the frame's front panel, gently pull on it.
2. Carefully place the SDA-122i between the module guides and gently push the module towards
the rear of the frame until the module's edge connector is secured to the backplane. Pull
lightly on the module verifying that it does not move.
3. Replace the frame's front panel.
2.3 Rear Panel Label
Connector labels have been shipped with the SDA-122i. These labels are to be installed on the
frames’ rear panel in order to identify the module's external connectors.
2.3.1 imaging Quartet/Quartet-C/Solo Frames
To install the Quartet/Quartet-C/Solo label, follow these steps while referring to Figure 2.1.
1. Remove the screws associated with the SDA-122i connectors.
2. Carefully apply the label to the connectors.
3. Replace the screws making sure not to damage the label.
Figure 2.1
Quartet/Solo rear panel label installation
SDA-122i label
imaging
Quartet,
imaging
Quartet C,
or
imaging
Solo
(top view)