2
2 Installation
2.1 Unpacking
Make sure the following items have been shipped with your SDA-122i. If any of the following items
are missing, contact your distributor or Miranda Technologies Inc.
•
SDA-122i Reclocked Digital Video Distribution Amplifier
•
SDA-122i rear panel labels (3)
•
This manual
2.2 SDA-122i Mechanical Installation
The SDA-122i must be mounted within Quartet, Quartet-C, Symphonie (using R-CX, R-C or R-M
rear module) or Solo
imaging
frames in order to provide power to the module. This section
describes how to install the SDA-122i in any of these frames
. Note that only the Symphonie
imaging
frame using the R-CX rear module allows to use the 7-output capability of the
SDA-122i
. It is not necessary to switch off the power from these frames when installing or
removing the SDA-122i.
2.2.1 imaging Quartet and Quartet-C Frames
To install this module into Quartet or Quartet-C follow these steps. For a closer look at module
installation and removal, refer to the frame's Guide to Installation and Operation.
1. Remove the frame's front panel by rotating the thumb screws counter-clockwise. Pull on the
handles.
2. Select an empty slot.
3. Carefully place the SDA-122i between a set of module guides and gently push the module
towards the rear of the frame until the module's edge connector is secured to the backplane.
Pull lightly on the module verifying that it does not move.
4. Replace the frame's front panel. Make sure to rotate the thumb screws clockwise in order to
secure it to the chassis.
2.2.2 imaging Symphonie Frame
To install this module into Symphonie follow these steps. For a closer look at module installation
and removal, refer to the frame's Guide to Installation and Operation.
1.
Remove the front panel door by pulling on the door handles and gently lowering it.
2.
Select an empty compartment.
3.
Carefully place the module between the module guides and slowly push the module towards
the rear of the frame until the module's edge connector is secured to its rear module. A light
pressure to mate the connectors may be required. Pull lightly on the module verifying that it
does not move.
4. Replace the front panel door.
