GUIDE TO INSTALLATION AND OPERATION
RCP-100 |
19
1. Insert the compact flash on RCP-100 panel (left). Wait for 2-3 seconds to allow RCP-100 to detect the
new device. The LCD screen will display the message “FLASH CARD DETECTED” for 1 second.
2. Push the "Esc" button rapidly 5 times (all within 5 seconds).
3. The upgrade procedure begins. The LCD screen will display the written flash sectors gradually; then it
will display the typ files loaded on the RCP-100.
4. If the upgrade finishes without errors, remove the Compact Flash card and restart the RCP-100.
If during the upgrade the error message “UPGRADE BIN FAILED” is displayed, do not reset/restart the RCP-
100 unit. Retry the upgrade starting with step 2.
If the error message “UPGRADE TYP FAILED” is displayed, reset the RCP-100 unit and retry the upgrade
procedure from the beginning.
5.2 Upgrading using Telnet and FTP
The RCP-100 Operating Software can be upgraded using the Telnet and WS_FTP software.
IMPORTANT NOTE:
Upgrading the RCP-100 to version 1.80 (0047) or to version 2.01 (0057) is only
possible if the RCP-100 was previously upgraded to version 1.71 (0042).
Required equipment:
PC with:
•
Ethernet card, connected to a network via an Ethernet cable;
•
Operating system: Windows 95,98,NT, 2000;
•
Telnet and WS_FTP software;
•
Ethernet cable to connect RCP-100 to the network, or a crossed Ethernet cable to connect RCP-100
to the computer.
The update includes loading the new version of the file rcp_update.bin and the files * typ in the flash memory
of the RCP-100.
1. Go to the Srvice Config screen (see page 12) and set ICOM, DCOM and DSRV to OFF. Remember to
press the encoder knob to save any changes. Then, restart the RCP-100.
2. Connect the Ethernet cable between RCP-100 and network or the crossed Ethernet cable between
RCP-100 and computer and the power supply cable to the RCP-100.
3. Start Telnet application and connect to RCP-100 via the RCP-100 IP address. The following message
will be displayed:
Telnet session
RCP-100 Telnet Shell session
RCP100.xxx>
Note: xxx will be the last group of the IP address of the RCP-100.
4. Type
makeupdatedisk
. The following message will be displayed:
