20
3.7 Installing an imaging Series Module
It is not necessary to switch off the power when installing a module into a housing
frame. To install a module, follow these steps.
1. Remove the front panel by rotating the thumb screws counter clockwise. Pull on
the handles.
2. Select an empty slot.
3. Carefully place the module between the module guides (refer to Figure 3.10)
and slowly push the module towards the rear of the housing frame until the
module's edge connector is secured to the backplane. Pull lightly on the module
verifying that it does not move.
4. Replace the front panel. Make sure to rotate the thumb screws clockwise in
order to secure the front panel to the chassis.
Figure 3.10
Module guide location
Module guides
1
0
Place module here
Place module here
3.8 Removing an imaging Series Module
It is not necessary to switch off the power when removing a module from a housing
frame. To remove a module, follow these steps.
1. Remove the front panel by rotating the thumb screws counter clockwise. Pull on
the handles.
2. Locate the module you wish to remove.
3. Carefully pull the module ejector until the module is detached from the internal
PCB edge connector. Slowly pull out the module.
4. Replace the front panel. Make sure to rotate the thumb screws clockwise in
order to secure the front panel to the chassis.