Miranda NV8256-Plus, Руководство пользователя

Страница: 16 / 88

6 Rev 1.3 • 29 Mar 09
2. Introduction
Power Supply
which router, what type of input card is used, and if the router requires output cards. For a descrip-
tion of each type of card, see
Active Cards on page 15. The two connected routers are listed as
Router 1 and Router 2. Although the examples list a full complement of input cards, the number of
cards installed depends on the number of inputs and outputs being managed by a specific switching
configuration. The optional, redundant crosspoint card (installed in the center crosspoint card slot)
is not included in the following examples. Only required crosspoint cards are listed.
Power Supply
The power supply for the NV8256-Plus is an external, separate frame, the NV6257. The NV6257
uses the PS6000 series power supply module. The NV8256-Plus router requires four PS6000 power
supply modules. For redundancy, an additional four PS6000 modules can be installed. The NV6257
can house a total of four primary and four redundant PS6000 power supply modules. This means
that one NV6257 power supply frame can power one NV8256-Plus router frame.
The PS6000 power supply module accepts a wide range of AC input voltages and produces five
+48 VDC outputs. The power supply automatically senses the AC input voltage (90–130 and 180–
250 VAC) and adjusts to maintain a relatively constant DC output; no voltage selection is required.
The five regulated outputs are directed to modules in the router where on-board regulators produce
the DC voltages required by the local circuits. Each +48VDC output powers one of the five green
LEDs and output test points located on the front of the power supply. Under normal operation, all
five LEDs are lit. For more information, see
Indicator LEDs on page 58.
Figure 2-1 shows the power supply architecture.
Figure 2-1. PS6000 Power Supply Module Diagram
For information on making power supply connections, see Making Power Connections on page 26.
Inputs ×
Outputs Number of
Frames
Number of
Crosspoint
Cards
Crosspoint
Card Slot Type of
Input Card Output Cards in
Router
256×256 1 1 Left Standard Router 1
256×512 2 2 Router 1: Left
Router 2: Right
Router 1: Standard
Router 2: Filler
Router 1,
Router 2
512×256 2 2 Router 1: Left, Right
Router 2: None Router 1: Standard
Router 2: Standard Only on
Router 1
512×512 2 4 Router 1: Left, Right
Router 2: Left, Right Router 1: Standard
Router 2: Standard Router 1,
Router 2
Power Sense
and Limiting
AC Input, Fuse,
Rectifiers, and Filter
Power Factor
Correction
+48VDC
Regulators (×5)
+48VDC
Out (×5)
90–130VAC or
180–250VAC In