GUIDE TO INSTALLATION AND OPERATION
CPU-ETH2 |
15
6 Local Controller Operation
Push the CTRL button on the local control panel to access the CPU-ETH2 card’s menu structure shown below. Here
is a summary of the top-level menu items and the content they access.
Status
If there are faults, the second line of the display initially shows “Status”. It then cycles through a list
of the current faults, for example: FAN2 FAILURE or PS1 FAILURE.
Host name
Reports the host name of the controller.
ETH1 Options
Allows the user to enable/disable DHCP, and to set the IP address, network mask and gateway
URL for the ETH1 port.
ETH2 Options
Allows the user to enable/disable DHCP, and to set the IP address, network mask and gateway
URL for the ETH2 port.
SNMP Options
Enable/disable the SNMP agent, and manage IP addresses for SNMP traps.
Restore points
Save the on-board data for all cards in the Densité frame, or for a designated card.
Time options
Sets up the method by which the CPU-ETH2 controller obtains time information.
Alarm Report
Allows the user to cycle through a list of alarms and choose whether each item will be reported on
the GPI port.
GPI Report
Allows the GPI output to be enabled or disabled; disable removes any existing fault report
CTRL Version
Returns the version number of the currently-installed firmware.
Factory Default
Restores factory default settings for all parameters (but not ethernet settings).
Upgrade
Perform a controller firmware upgrade.
CTRL Execution
Reboot the controller card.
USO
RESTRITO
