Use Instructions
Before proceeding make sure you understand the warnings section of this manual.
Lighting instructions:
• Turn on gas supply at cylinder.
• Push dial in and turn to position .
• While dial is held pressed in at position , press spark button repeatedly to ignite the burner.
• Hold dial in for at least 10 seconds to ensure heater stays lit.
• If burner does not light after holding dial in for 20 seconds wait 5 minutes and try again.
Do not continuously hold the dial in as you may cause a build up of gas.
• In windy conditions shield from wind to ensure easy lighting and hold dial in for at least 20
seconds to ensure heater stays lit.
• Turn control dial to high or low flame position as required.
• Correct operation of the burner is indicated by a predominantly blue quiet flame.
If the piezo sparker fails you can light your patio heater using a match.
To light Patio Heater with match:
1. Place lit match through the gap below the burner mesh and wind guard.
2. Turn the control dial to the position. After burner igniteskeep control dial held
in for 10 seconds to ensure burner stays lit and then release.
3. If the burner does not light after holding the control dial in for 20 seconds with the lit
match in position, remove the match, turn the control dial to the off position, wait 5 minutes and
then repeat.
To Turn Off:
• Push dial in and turn to position .
• Turn the gas
off
and disconnect at the cylinder when not in use.
Flame Characteristic
The flame pattern at the burner mesh should be visually checked whenever the heater
is operated. Normally the burner flame is blue with yellow flame at the top.
The Burner mesh will become red hot.
If flames extend beyond the surface of the burner mesh, or the phenomena of
flame lift or light back, or black spot is accumulating on the burner mesh or reflector,
the heater should be turned off immediately. The heater should not be operated again
until the unit is serviced or repaired.
Care and Maintenance
• Regularly clean your patio heater between uses and especially after extended periods of storage.
• Ensure the heater control is turned fully to the off position. the gas supply is shut off at the regulator
or bottle / cylinder valve, and the heater and its components are sufficiently cool before cleaning.
• Never douse the heater with water when its surfaces are hot.
• We recommend that servicing of this appliance should be performed either after every 100
hours of use or annually, which ever is achieved soonest.
Fixings
All screws and bolts, etc, should be checked and tightened on a regular basis
.
Storage
• Do not leave the patio heater exposed to outside weather conditions or stored in damp
moist conditions.
• To save space during long-term storage, the reflector can be removed. Take care to ensure
the shape of the reflector is not damaged or deformed, as this will affect performance.
Page 15
Yellow Tip
Primary blue
flame
Reflector
Burner mesh
