Mirage B-
320
-G Instruction Manual
-
3-
EXPLANATION OF FEATURES
FRONT PANEL
1.
OUTPUT POWER LED
2. MODE
LED
3. PRE-AMP
LED
The PRE-AMP LED will illuminate when the pre-amp is
engaged. The pre-amp can be used independently even
if the amplifier's power is off.
4. PWR
LED
If the LED is in the off position the amplifier will pass the
RF in a straight through mode. This means that both
the receive and transmit signal will bypass the internal
circuitry of the amplifier. If the LED is illuminated then
the amplifier is in the standby mode and will amplify any
signal that is supplied to its input of more than 250 mW.
5.
SWR Fault LED
6.
MODE (SSB/FM) SWITCH
When in the SSB mode the amplifier will delay the
change over time of the carrier operated transmit relay
to 1 second before disengaging. This will prevent relay
chatter as a result of working SSB or CW. In the FM
mode the relay will operate normally and disengage once
the transmit signal is dropped.