6B
No need to turn the unit off when you change the DMX address, as new DMX address
setting will be effected at once. Every time you turn the unit on, it will show the type on the
display and move all the motors to their ‘home’ position and you may hear some noises for
about 20 seconds. After that the unit will be ready to receive DMX signal or run the built in
programs.
4.1 Master/Slave Built In Preprogrammed Function
By linking the units in master/slave connection, the first unit will control the other units to
give an automatic, sound activated, synchronized light show. This function is good when you
want an instant show. You have to set the first unit in master mode
and select
(show 1) or
(show 2) or
(show 3) or
(show 4) mode. Its
DMX input jack will have nothing plugged into it, and Its master LED will be constantly on
and sound LED will flash to the music. The other units will have to set in slave mode
and select
(normal) or
(2 light show) mode, Their DMX cables plugged into
the DMX input jacks (daisy chain) and the slave led lights will constantly on.
2-light show
In
(slave mode),
means the unit works normally and
means
2-light show. In order to create a great light show, you can set
on the second unit to
get contrast movement to each other, even if you have two units only.
4.2. Easy Controller (by CA-8)
The easy remote control is used only in master/slave mode. There is a terminator for
connect the easy controller inside the fixture. By connecting the cable into DMX IN
waterproof cable entry gland to the CA-8 terminator of the first fixture, you will find that the
remote control on the first fixture will control all the other fixtures for Stand by, Function and
Mode functions.
Blackout
Blackout the unit
Function
Random (Fast)
Random (Slow)
Chase Select
(Chase 1-12)
Mode
(LED OFF)
(LED ON)
(LED Strobe)
