Mira Miniduo, Инструкция по установке и эксплуатации

Страница: 23 / 32

23
OPERATION
Mira Moto , Mira Minilite and Mira Minilite Eco
thermostatic mixers have a single sequential
control lever for on/off and temperature control.
The control lever operates anti-clockwise in the
following sequence:
•
Off
•
On
•
Cold
•
Warm
•
Maximum Preset Temperature
Maximum Preset
Temperature
Off
Mira Pace, Mira Pace with Eco Showerhead,
Mira Miniduo and Mira Miniduo with Eco
Showerhead thermostatic mixers have separate
control levers for on/off and temperature.
The control levers operate as shown below:
Off
Turn the Temperature Control
Handle clockwise to decrease the
temperature and anticlockwise to
the preset maximum temperature
Turn the Flow Lever
anticlockwise to the
preset maximum flow
On
Hot
Cold
COMMISSIONING
Maximum Temperature Setting
Before using the shower the maximum temperature
must be checked to make sure that it is at a
safe level. It has been preset to approximately
41°C at the factory but due to variations in site
conditions the maximum temperature may need
adjustment.
Note! Make sure that the hot water temperature
is at least 55°C and that there is sufficient supply.
For Type 2 installations the maximum blend
temperature is determined by the application,
refer to section:
‘Type 2 Valves - Application’
.
1. Turn on the mixer to the maximum temperature
and maximum flow (i.e. fully anticlockwise) and
allow the temperature to stabilise.
If the temperature is too hot or too cold adjust
as follows:
2. Carefully remove the concealing cap from the
control knob.
3. Loosen the control lever grubscrew with the
2.5 mm hexagon key (supplied) and pull off
the control lever.
4.
If applicable unscrew the hub retaining screw
with a 2.5 mm hexagon key.
Note! Do not remove the hub.
Control Lever
Hub
Hub Retaining
Screw
Grubscrew
+
-
+
-
Concealing Cap
2.5 mm Hexagonal Key
Flow Control
Lever
Or