INSTALLING OPTIONAL
BAG RETAINING SYSTEM
Lid
Bag frame
Plastic loop
Nipple
9100 Ray Lawson blvd , Anjou, Québec
H1J 1K8
Tel.: (514) 356-1224 Fax: (514) 356-0055
Toll free (US & CANADA) (800) 361-4964
E-Mail: [email protected]
site web: www.mipinc.com
?
Attach small end of tubing onto nipple protruding from back of lid
First install bag on bag frame. Then stretch
tubing over bag and use hooks on bag frame
to maintain tubing in place. When not in use,
tubing should be hanging from back of lid.
Installing foot pedal system
The foot pedal system can be installed on all of our carts including the LC-2000 series. Older carts might have inappropriate lids. The
appropriate ones have an embossed Med-I-Cart logo. If this not the case, contact our customer service department, they will provide you
with a free lid for every purchase of our foot-pedal system.
Parts included:
Foot pedal
Lifting
rod
Lid lift
lever
Foot pedal retaining clip
Tools required: Drill with 5/32” (4mm) bit; screwdriver; felt tip marker;
pair of pliers
?
Begin with assembled cart. Do not
install lid immediately.
a. Insert bottom end of rod in the slot
of the pedal b. It will be a tight fit c.
Lift rod as indicated.
b.
c.
?
a) Position the pedal underneath the cart. Clip it on the
central bar of the cart base b) Position the pedal so that the
lifting rod is 1/4” (6mm) away from the bag frame. Make
sure that the rod is on the same side as the lid stoppers on
the bag frame.
?
b)
a)Place lid lift lever under side frame close to bag frame
b) Insert top extremity of the lifting rod into the lift lever’s
hole c) Clip the lid over the lift lever. Push lid lift lever to
the lid.
Use a marker to indicate where you should drill b. Move
the lid lift away for easier access. A 5/32” (4 mm) bit is
required on your drill. After drilling push the lid lift lever
back to the lid.
Note: Do not mark holes with lids off.
Alignement might be incorrect.
?
a)
c)
a)
b)
?
Push the bolt through the
lid and the lid lift lever,
screw the nut on. Using a
pair of pliers to hold the
nut, tighten it using a
screwdriver.
?
Position the foot pedal
retainer clip into recessed
space. Attach with two screws.
Only tighten enough to insure
that screws are fully inserted
in plastic. Overtightening
might strip plastic.
