Minuteman PowerBoss 3800, Операционное обслуживание комплектующих и уход

Страница: 5 / 23

3
OPERATION
TO SWEEP:
1. Turn on 3800 Rider power.
2. Move “Presweep Switch” (in operator compartment) to down position.
3. Drive machine.
TO STOP SWEEPING:
1. Move “Presweep Switch” to up position.
2. Allow filter shaker to finish before turning off 3800 Rider power.
TO EMPTY HOPPER:
1. Move “Presweep Switch” to down position.
2. After Sweeper pivots down, move “Presweep Switch” to neutral (middle) position.
3. Depress Red Emergency Disconnect Switch on 3800 Rider.
4. Pull hopper from front of machine using finger hold on bottom of hopper.
MAIN BROOM ADJUSTMENT (Fig. 5)
BROOM HOPPER ADJUSTMENT IS PERFORMED AS FOLLOWS:
1. Remove hopper.
2. Tighten bottom nut to lower brush and tighten upper nut to raise broom.
3. Replace hopper.
Broom should be in contact with the floor when deployed. When pre-sweep
is raised, broom should not be in contact with the floor.