8
1.
To assist you, we suggest using a piece of wood doweling
or plastic material 5/8" diameter, 2" long as shown. Each
pinion is different as indicated by the part number and
must be returned to the correct side of the shaft.
2.
Insert the wooden dowel into the pinion.
3.
Identify your pinion part number and insert the metal
rollers. Place the plastic tubing in the cavity between the
metal roller and the wall of the cavity. You may have to
force the plastic tubing into this space but it is resilient
and is supposed to fit tightly.
NOTE!
The right and left side are determined from the
operators position.
4.
Pinion with part number 74-79 LB is to be replaced on the
left side
of the shaft. Part number 74-78 RB is for the right
side. Line up the pinion (leaving the dowel in place) with
the shaft as shown.
5.
Push the pinion onto the shaft which will force the dowel
to back out of the pinion. This will leave the rollers and
plastic tubes in their proper position.
6.
Apply a coating of grease on the outside of the wheel gear
teeth. Do not grease inside pinions this will cause pawl
springs to be ineffective.
HOW TO RE-INSTALL PINIONS
If for some reason you have found it necessary to remove the pinions, you should carefully follow these instructions. All parts
must be clean before assembling.
Содержание Kleen Sweep 27 C89000-00
Страница 1: ...Model C89000 00 Kleen Sweep 27 Revised 8 02 OPERATION SERVICE PARTS CARE...
Страница 4: ...3...
Страница 5: ...4...
