Minuteman HM40B, Руководство по обслуживанию

Страница: 22 / 39

6.3 Calibrate Drive Potentiometer
When replacing the controller or the drive potentiometer, the controller has to be adapted to the
potentiometer.
1 P “MODE” k d l t t “F20” i th “UP” k k l d ith “MODE” k 1. Press “MODE” key and select parameter “F20” using the “UP” key, acknowledge with “MODE” key.
2. Set numeric value of “F20” to “1” using the “UP” key. (Caution: if the programming level has not
yet been invoked, password level is displayed)
3. Enter password and acknowledge with “Mode” key.
4
R l t t “F20” ith “UP”/“DOWN” k d k l d ith “MODE” k 4. Re-select parameter “F20” with “UP”/“DOWN” keys and acknowledge with “MODE” key.
Set numeric value of “F20” to “1” using the “UP” key and acknowledge.
5. Select parameter “F10” with “DOWN” key and acknowledge with “MODE” key
6. The display then shows the “0” value. If not, use the “UP”/”DOWN” keys to set it to “0” and
k l d ith “MODE” acknowledge with “MODE”.
7. The display then shows “F10” again.
8. While the displays shows “F10“, press the “UP” and “DOWN” keys simultaneously for some seconds
until the display changes.
The left bottom LED segment then shows a “-“ (minus sign) while the
right-hand LED segment displays a potentiometer voltage parameter
between “0” and “5”.
Acknowledge this value with “MODE” key while the drive pedal is in
Acknowledge this value with MODE key while the drive pedal is in
neutral position.
22