Minuteman HM40B, Руководство по обслуживанию

Страница: 20 / 39

6.2 Programming The Drive Controller
• Enter Password
(Password for potentiometer setting only)
• Use the “UP” and “Down” keys to select the first and flashing number of the three-digit password
and acknowledge by pressing the “Mode” key. Then, enter and acknowledge the next flashing
central cipher alike
central cipher alike.
• Upon entering and acknowledging the last, right-hand cipher and in total, the correct password,
display changes to the last parameter or to “F0”
• If entering of one of the three ciphers is incorrect, complete the procedure until after entering if the
last cipher and acknowledgement by “MODE” the display shows “Err” briefly Then repeat the
last cipher and acknowledgement by MODE the display shows Err briefly. Then repeat the
complete entering procedure.
• Modify Parameter
In some cases, the 5-pin plug of the K3 relay in the machine has to be disconnected p p g y
before programming the controller.
After correct entering of password, the parameter “F..” selected before appears in the display.
Invoke the numeric value of the parameter by pressing the “MODE” key.
Modify this numeric value of the selected parameter by the “UP/“DOWN” keys
Modify this numeric value of the selected parameter by the UP/ DOWN keys.
Acknowledge modification by pressing the “MODE” key.
Then the selected parameter “F..“ is displayed.
20