6
The tire must be positioned in the center area of the drive
roller (see Fig. L).
If the tire is in contact or touching the other part of the
resistance unit rather than the drive roller (see Fig. M),
adjust the wheel position with the following steps;
1. Loosen the right side Hub Handle.
2. Loosen the left side Hub Adjust Bolt to open the left
side coupling.
3. Clamp the rear wheel axle again.
4. Tighten the Hub Handle firmly.
<Fig. L>
<Fig. M>
<Fig. N>
<Fig. O>
HOW TO ADJUST THE REMOTE CABLE
Outer Cable
Cable Cap
Inner Cable
If you cannot shift to either L or H, it's the time to adjust the
cable tension.
1. Set the remote shifter at "H" position.
2. Pull and remove the Cable Cap.
3. Pull out the inside adjusting screw until it touches the
Outer Cable.
4. While holding this position, tighten the nut until it touches
the unit body.
5. Put the Cable Cap again.
STORAGE
Fold the resistance unit at the rear pivot between
the Sub Frame and the Mount Base to minimize
the trainer and to protect the fins on the fluid side.
- 8 -