PIVOT CAUTION
The pivot between the Main Frame and the
Sub Frame should be tightened firmly for easier
installation of your bike onto VFS-G.
The 6mm Hex Wrench is located in the L-shaped
groove on the Sub Frame.
Use this tool to tighten the pivot bolts.
CAUTION:
To much tightening may break the Sub Frame.
Stop tightening when the Main Frame won't
drop down with its own weight.
6mm Hex Wrench
INSTALLING YOUR BIKE ON VFS-G
1
2
Open the couplings by turning both the Hub
Handle and the Hub Knob Bolt in a clockwise
direction.
The left side Hub Knob Bolt is just an initial
adjuster. Once the position is set, you do not
need to adjust the Hub Knob Bolt every time.
For more inforation, please refer the Step-6.
Pull up on the main frame so the unit is as
vertical as possible. This will make the rear
wheel installation easier (see Fig. H & G).
If the pivot bolts are loose, the Main Frame will
drop down with its own weight, so it is crucial
to tighten the pivot bolts firmly.
<Fig. F>
<Fig. G>
<Fig. H>
- 6 -