- 5 -
!
Hold the bike firmly by hand and turn the right side hub handle clockwise until the coupling comes
into contact with the right side skewer nut.
5
6
(Fig. F)
Adjust each height of the Mag unit and the assistant
roller to fit to your rear wheel perfectly and tighten
the bolts firmly. (see Fig. F)
(Fig. G)
7
Adjust the wheel position by checking the double-
circle position indicators on both side.
The best position should be each indicator can be
seen equally, but if your rim is narrow, you should
adjust the wheel position to be a little left (toward
Mag side) to prevent unexpected slippage problem.
NOTE:
Note that the left side knob is NOT for
tightening the axle. It is only for pre-
positioning the wheel. Clamping wheel
securely must be done by the right side
Hub Handle.
THE SKEWER NUT PROTECTOR
We strongly recommend you to use the supplied skewer at all times if
your rear wheel is a quick release skewer system. This will guarantee a
fit with our couplings and remove any chance of misalignment.
(Fig. H)
The right side coupling has a black plastic Skewer Nut Protector (called a “Grommet”). This is to protect
the skewer nut from damage during use.
If your rear wheel is not designed for the quick release skewer and uses a hub nut system, you should re
-
move it by inserting a rod or a pen to the hole (see Fig. H) and then lifting up the Grommet.
NOTE:
We will NOT guarantee any fitting problem or accident caused by using your own skewer
on the trainer.
NOTE:
When you use the supplied skewer, you should keep the Grommet on the coupling.
Hole
Each rubber roller is made to contact
the rim ONLY. Contact with the tire may
cause the tire to burst during use.
Skewer Nut Protector (Grommet)
